Bioer GeneQ Thermal Cycler, Manual, Page: 20 / 33

Gene Q Thermal Cycler Chapter 4 Operation Guide
— 14 —
When the file is normally running, “

” at
“Now Running” will continuously flash.
When running is over, the system will
remind “File running is over ,Press ‘Enter’
back to the main interface.”.
 Press “ Stop ” and it will remind “Do you
want to stop running? Please select
‘F1’ or ‘F3’”.According to the reminding
information to select “Stop” or “Start”.
 Press “ Pause ” and it will remind
“Pause state now. Press ‘F3’ to
continue running.” According to the
reminding information you can select
“Strat” to continue.
 Press “ View File ” to view edited PCR
programs.

Press “ Skip ” to stop current
temperature and run the next.
3
How to Set System Parameters
In the main interface press “ System ” to
enter system parameter setting interface.
Press “
Enter ” to move the cursor to next
item. The option is followed by the symbol
“ ”. Press “
Up/Down ” to roll the option for
selecting, and other information can be
entered by pressing “
Digit & Letter ”. Press
“ Right/Left” to move cursor’s position.
 Press “ Back ” to go back to the main
menu.
 Press “ Save ” to save parameters.
Special Reminding: When set the
parameter, please press the “Save”,
otherwise the parameter remains the
original one.
3.1 “Date”and“Time”stand for default time after power-on.
3.2 “Default File” and “Default User” stand for name and user of default running procedure after
power-on.
3.3 “Module Select” stands for module type, including two optional modes, named “18*0.5” and
“24*0.2”. Selecting the module type according to the real situation.
3.4 “Control Mode” stands for default control model after power-on, including two optional modes,
named “Block” and “Tube”.
“Block” mode subjects to simple temperature control during the course of cooling & heating
only. Compared to the block, cooling & heating rate of reagent is a little slower, therefore, the
actual change of reagent’s temperature is different from the setting procedure. The actual time
for reagent to reach & keep the setting temperature is far shorter than the setting time.
File running interface
System Parameter Setting Interface
Hotlid=off 2007-11-1 10:05:00
100
75
50
25
0
Temp
1c 95.0 2c 55.0 3c 72.0 4 04.0
Time
1:00 02:00 01:45 00:00
File Name:PCR1
User: BIOER Now Running

1c Temp=00.0 Time=00:00 Cycle 01 of 10
Total Time: 00h 56m Remainig Time:00h 56m
Stop Pause Start Skip View File
Hotlid=off 2007-07-28 10:06:00
Date(yy-mm-dd): 07-07-28
Time(hh-mm-ss): 10:06:19
Default User: BIOER
Default File: PCR1
Module Select: 24*0.2
Control Mode: Block
Hotlid Temp: OFF
Block Temp: 10C
Key Sound: OFF
Run End Sound: ON
Back Save