Binder 9020-0402, Translation Of The Original Operating Manual

Page: 46 / 173

MK LIT (E5) 01/2021 page 46/172
8. Completeness of delivery, transportation, storage, and installation
8.1 Unpacking, and checking equipment and completeness of delivery
After unpacking, please check the chamber and its optional accessories, if any, based on the delivery
receipt for completeness and for transportation damage. Inform the carrier immediately if transportation
damage has occurred.
The final tests of the manufacturer may cause traces of the shelves on the inner surfaces. This has no
impact on the function and performance of the chamber.
Please remove any transportation protection devices and adhesives in/on the chamber and on the doors
and take out the operating manuals and accessory equipment.
Remove the upholstered transport piece (L-type profile)
from the lower door locking and keep it for possible later
transportation.
Figure 15:
Door locking with transport piece (state of delivery)
CAUTION
Risk of injury and damages by lifting heavy loads and by sliding or tilting of the
chamber due to improper lifting.
Injuries, damage to the chamber.
∅ Do NOT lift or transport the chamber using the door, the handle or the lower housing.
∅ Do NOT lift the chamber by hand.

Keep the chamber in upright position.

Lift chambers from the pallet using technical devices (fork lifter). Set the fork lifter only
from the rear in the middle of the chamber. Make sure to place all the lateral supports
of the chamber on the forks.
If you need to return the chamber, please use the original packing and observe the guidelines for safe lifting
and transportation (chap. 8.2).
For disposal of the transport packing, see chap. 29.1.
Note on second-hand chambers ( Ex-Demo-Units):
Second-hand chambers are chambers that were used for a short time for tests or exhibitions. They are
thoroughly tested before resale. BINDER ensures that the chamber is technically sound and will work flaw-
lessly.
Second-hand chambers are marked with a sticker on the chamber door. Please remove the sticker before
commissioning the chamber.