Billion BiPAC 4500NZ(L), User Manual

Page: 51 / 146

48
IPv4 Options
Get IP Address:
Choose Static or Dynamic
Static IP Address:
If Static is selected in the above field, please enter the specific IP address you get
from ISP and the following IP subnet mask and gateway address.
IP Subnet Mask:
The default is 0.0.0.0. User can change it to other such as 255.255.255.0.Type the
subnet mask assigned to you by your ISP (if given).
Gateway:
Enter the specific gateway IP address you get from ISP.
NAT:
Select Enable if you use this router to hold a group of PCs to get access to the internet.
Dynamic Route:

RIP Version:
(Routing Information protocol) Select this option to specify the RIP version,
including RIP-1, RIP-2.

RIP Direction:
Select this option to specify the RIP direction.
-
None
is for disabling the RIP function.
-
Both
means the router will periodically send routing information and accept routing
information then incorporate into routing table.
-
IN only
means the router will only accept but will not send RIP packet.
-
OUT only
means the router will only send but will not accept RIP packet.
TCP MTU Option:
Maximum Transmission Unit, the maximum is 1500.
IGMP Proxy:
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish
membership in a Multicast group. Choose whether enable IGMP proxy.
IPv6 options
(only when choose IPv4/IPv6 or just IPv6 in IP version field above):
IPv6 Address:
Type the WAN IPv6 address from your ISP.
Obtain IPv6 DNS:
Choose if you want to obtain DNS automatically.
Primary/Secondary:
if you choose Disable in the Obtain IPv6 DNS field, please type the exactly
primary and secondary DNS.
MLD Proxy:
MLD (Multicast Listener Discovery Protocol) is to IPv6 just as IGMP to IPv4. It is a
Multicast Management protocol for IPv6 multicast packets.
When router’s Internet configuration is finished successfully, you can go to status to get the connection
information.