47
ISP Connection Type:
ISP:
Select the encapsulation type your ISP uses.
Dynamic IP:
Select this option if your ISP provides you an IP address automatically.
Static IP:
Select this option to set static IP information. You will need to enter in the Connection
type, IP address, subnet mask, and gateway address, provided to you by your ISP. Each IP
address entered in the fields must be in the appropriate IP form. IP address from by four IP
octets separated by a dot (xx.xx.xx.xx). The Router will not accept the IP address if it is not in
this format.
PPPoE:
Select this option if your ISP requires you to use a PPPoE connection.
Bridge:
Select this mode if you want to use this device as an OSI Layer 2 device like a switch.
802.1q Options
802.1q:
When activated, please enter a VLAN ID.
VLAN ID:
It is a parameter to specify the VLAN which the frame belongs. Enter the VLAN ID
identification, tagged: 0-4095.
PPPoE (If selected PPPoE as WAN Connection Type; otherwise, skip this part)
Username:
Enter the user name provided by your ISP.
Password:
Enter the password provided by your ISP.
Bridge Interface for PPPoE:
When “Activated”, the device will gain WAN IP from your ISP with the
PPPoE account. But if your PC is connected to the router working as a DHCP client, in this mode, the
device acts as a NAT router; while if you dial up with the account within your PC, the device will then
work as a bridge forwarding the PPPoE information to the PPPoE server and send the response to
your PC, thus your PC gets a WAN IP working in the internet.
Connection Setting
Connection:
Always On:
Click on
Always On
to establish a PPPoE session during start up and to
automatically re-establish the PPPoE session when disconnected by the ISP.
Connect Manually:
Select Connect Manually when you don't want the connection up all the
time.
TCP MSS Option:
Enter the maximum size of the data that TCP can send in a segment. Maximum
Segment Size (MSS).
IP Options
Default Route:
Select
Yes
to use this interface as default route interface.
TCP MTU Option:
Enter the maximum packet that can be transmitted. Default MTU is set to 1492.
Summary of Contents for BiPAC 4500NZ(L)
