Berthold BTwave LB 571-02, Operating Manual

Page: 29 / 52

LB 571 BTwave 6 Start up and Calibration
68847BA2 Rev.00, 10/2020
25
6.4 Writing and reading product parameters
Device parameters can be saved to and read from device using Parameters tab and
selecting Device. A comment explaines the function of each parameter
Figure 16 Device parameters
Load from device : Loads parameters from sensor FLASH memory to PC.
Save to device
: Saves parameters to sensor FLASH memory and also to SD-card
parameters folder as ASCII –file.
Load from PC : Loads parameters from UI settings –folder from file
DeviceParameters.XML .
Save to PC: Saves parameters to UI settings –folder to file
DeviceParameters.XML
Parameters saved to device SD-card are only a copy of internal FLASH-memory
contents. Parameters are never copied from SD-card to FLASH-memory.
Only the following parameters may need changes during start-up:
And their meanings are as follows:
3# Min_moisture (%) : Minimum moisture reading in % given out by device.
Default 0 %.
4# Max_moisture (%) : Maximum moisture reading in % given out by device.
Default 100 %.
5# AO1_I_min : Analog output channel 1 minimum current output (mA)
value. Output calibrated to 4 mA during production.
Channel disabled if set to -1. Default 4 mA.
7# AO1_scale_min (%) : Analog output channel 1 minimum moisture (%) value.
Default 0 %.
8# AO1_scale_max (%) : Analog output channel 1 maximum moisture (%) value.
Default 100 %.
10# AO2_I_min : Analog output channel 1 minimum current output (mA)
value. Output calibrated to 4 mA during production.
Channel disabled if set to -1. Default 4 mA.
12# AO2_scale_min (°C) :Analog output channel 2 minimum material temperature
(°C) value. Default 0 °C.