79
Section 3 - Programming from PC
Figure 3.16 - Code Page
The parameters programmed in this page (see Figure 3.16) will determine the
different access levels of the Codes. This system can manage up to 25 Codes.
Codes 1 through 24 are User Codes, and Code 25 is the Installer Code. The Codes
can comprise 4, 5 or 6 digits.
A
Use of 4 digit Codes will down-grade the System Performance level
from Level II to Level I.
User Code Table
The User Codes can Arm/Disarm the system and perform various operations, in
accordance with their programmed access levels (refer to the USER MANUAL).
No.
- This column shows the Code Number (1 through 25).
Description
- This field will allow you enter the Code label (max. 16 letters).
1, 2, 3, 4, 5, 6, 7, 8
- These numbers correspond to the 8 Partitions. The Codes
can be programmed to operate in 3 different modes on the system Partitions, as
follows:
Type On/Off
(Red) - This row will allow you to Enable/Disable the Code on
the Partition (
= Code enabled on the relative Partition).
A
Mode
(Amber) - This row will allow you to enable the status the Partition
will assume when the Code makes an
A Mode
Arming request. The box will
indicate the selected mode (see the
Mode
section—top right of the ’Code
Page’). Refer to Table 3.1. for
A Mode
programming instructions.
Code Page
Summary of Contents for KYO 32 M
Page 1: ...0 1 7 167 7 21 0 18 ...
Page 10: ...10 Multifunction Control Panel The NC2 TAST LED Keypad Figure 1 3 The NC2 TAST LED Keypad D D ...
Page 71: ...71 Section 3 Programming from PC 5 11 6 0 1 2 3 1 4 3 3 5 2 3 0 1 2 3 ...
Page 88: ...ISTISBLEUNKYO 2 6 160108 P70 17 6 85 7 6 U O 01 02 5HF FOLQ LQ RU WLRQ ...
