54
LCD Displays
Figure 26: Drive is in rem mode
FWD At Spd T/K
60.0Hz +0%
FWD At Spd LOC
60.0Hz +0%
5 - KEYPAD OPERATION AND PROGRAMMING
5.6 LCD Displays
5.6.1 Control (loc/rem) button
The characters in the top right hand corner of the operate screen show the source of control for the drive:
Modes (loc/rem) key can be set as:
Figure 25: Drive is in loc mode
In figure 25 the drive is in loc mode which means the Start/Stop & Speed reference control paths come
from the keypad.
In figure 26 the T/K is an example of one of the control sources during remote mode. The chart above
shows all the paths that may be set. The first letter (T in example) is for parameter DRV 04 - Drive Mode
1 and will set the control (run command) source. The second letter (K in example) is for DRV 05 - Freq
Mode 1 and will set the reference (speed) source.
z
NOTE:
If the drive is running and the “loc/rem” button is pressed, the drive will stop if the new control
source does not have a run command.
z
NOTE:
To disable this button go to page
AFN 21 - loc/rem button.
Display Value for Remote Mode
Meaning
LOC
Local control via the keypad
K/K
Keypad control / Keypad reference
K/T
Keypad control / Terminal reference
T/K
Terminal control / Keypad reference
T/T
Terminal control / Terminal reference
S/K
Serial control / Keypad reference
S/T
Serial control / Terminal reference
S/S
Serial control / Serial reference
T/S
Terminal control / Serial reference
K/S
Keypad control / Serial reference
Summary of Contents for RSi S4 Series
