![background image](http://html.mh-extra.com/html/benq/su931/su931_user-manual_2735001044.webp)
44
Using the projector
En
gl
ish
Controlling the projector through a Wired
LAN environment
Wired LAN
allows you to manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end
to the RJ45 port.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or
interruption.
2. Press
MENU/EXIT
and then press / until the
System Setup: Advanced
menu is highlighted.
3. Press
to
highlight
Network Settings
and press
MODE/ENTER
. The
Network Settings
page
is displayed.
4. Press
to
highlight
Wired LAN
and press
MODE/ENTER
. The
Wired LAN
page is displayed.
5. Press
to
highlight
DHCP
and press / to select
On
.
6. Press
to
highlight
Apply
and press
MODE/ENTER
.
7. Go back to
System Setup: Advanced
>
Network Settings
page.
8. Press
to
highlight
AMX Device Discovery
and press / to select
On
or
Off
. When
AMX
Device Discovery
is
On
, the projector can be detected by AMX controller.
9. Please wait for around 15 - 20 seconds, and then re-enter the
Wired LAN
page.
10. The
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings will be displayed.
Note down the IP address displayed in the
IP Address
row.
If the IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
to
highlight
DHCP
and press / to select
Off
.
3. Contact your ITS administrator for information on the
IP Address
,
Subnet Mask
,
Default
Gateway
, and
DNS Server
settings.
4. Press to select the item you want to modify and press
MODE/ENTER
.
5. Press / to move the cursor and then press / to enter the value.
6. To save the setting, press
MODE/ENTER
. If you do not want to save the setting, press
MENU/
EXIT
.
7. Press
MENU/EXIT
to return to
Network Settings
page, press to highlight
AMX Device
Discovery
and press / to select
On
or
Off
.
8. Press
MENU/EXIT
to exit the menu.