SYSTEM INSTALLATION MANUAL
89000016
Figure 1007. (Sheet 1 of 1) KGX Control Panel Static Pressure Connection
(4)
For aircraft with 1/4-inch (6.3-mm) static lines, two adapters are provided which can convert
from 1/4-inch (6.3-mm) inside diameter hoses to the 0.2-inch (5-mm) hose in the install kit.
(5)
In all cases, the static line must include drainage provisions and must be routed in accordance
with CS 23.1325 or other applicable airworthiness provisions for the aircraft.
17. Equipment Limitations
A.
General
(1)
The CDTIs integrated with this article must be analyzed for latency. This article ownship and
traffic total latency is less than 1.25 seconds and the uncompensated latency is 0 seconds
from current UTC second (not including serial data transmission time).
(2)
The antenna installation must comply with the specifications in Paragraph 14 for UAT antennas
and Paragraph 15 for GPS antennas.
(3)
For a compliant installation in accordance with the TSO and the FAR, the KGX installation must
meet the following requirements.
NOTE:
Certified installations must be approved by a STC or a TC.
B.
TSO-C145c (KGX 150 Series Only)
(1)
“The conditions and tests required for TSO approval of this article are minimum performance
standards. Those installing this article, on or in a specific type or class of aircraft, must
determine that the aircraft installation conditions are within the TSO standards. TSO articles
must have separate approval for installation in an aircraft. The article may be installed only
according to 14 CFR Part 43 or the applicable airworthiness requirements.”
C.
TSO-C154c
(1)
“This article meets the minimum performance and quality control standards required by a
technical standard order (TSO). If you are installing this article on or in a specific type or class
of aircraft, you must obtain separate approval for installation.”
EFFECTIVITY
ALL
Page 1025
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.