SYSTEM INSTALLATION MANUAL
89000016
WIFI MODULE
1.
General Information
A.
Introduction
(1)
This section contains the system installation guidance for the BendixKing WiFi module, PN
89000016-002. The WiFi module provides a robust and affordable solution of transmitting
data wirelessly.
B.
System Description
(1)
The BendixKing WiFi module is a complete stand-alone embedded wireless LAN access
device. The device has on board TCP/IP stack and applications, requiring only four pins
(power, 232-TX, 232-RX, GND) to design in for basic usage. The WiFi module is pre-loaded
with firmware to simplify integration and minimize applications development time.
C.
WiFi Module Installation Overview
(1)
Connectors
(a)
Connectors present on the WiFi module are as follows:
• Signal / Power (DB-15)
• Signal / WiFi Antenna (SMA).
NOTE:
The WiFi module SMA antenna is preinstalled with the system.
(2)
Status Lights
(a)
Three system status LEDs are present on the front face of the WiFi module. Refer to
Figure 8001.
(b)
WiFi Status LEDs
1
Three status LEDs (AS, T/R, IP) indicate the operational status of the WiFi module
interface. Table 8001 describes the LED indicators.
Table 8001. LED Indicators
Condition
Red LED (AS)
Yellow LED (Tx/Rx)
Green LED (IP)
On solid
-
-
Connected
Fast blink
Not associated
Tx/Rx data transfer
No IP address
Slow blink
Associated, no internet
-
IP address OK
Off
Associated, internet OK
-
-
Figure 8001. (Sheet 1 of 1) WiFi Module Front Face
EFFECTIVITY
ALL
Page 8001
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.