SYSTEM INSTALLATION MANUAL
89000016
(5)
Terminal Program Interface
(a)
“Tera Term” (or another terminal interface program) must be installed on the PC and an
MPI connection made through serial port or WiFi depending on the interface device used.
The following paragraphs detail the serial port settings and WiFi settings.
1
Tera Term Terminal Setup (refer to Figure 3006)
a
Local Echo – checked.
b
The default MPI port settings for a serial connection are shown in Table 3021
and Figure 3007. These settings applicable to all MPI devices (USB-to-serial,
MPI module, and aircraft WiFi module)
Table 3021. Default MPI Port Configuration Settings
MPI Port
Baud
Parity
Data
Stop
Flow Control
3
38400
Odd
1
8 Bit
1 Bit
None
5
115200
None
8 Bit
1 Bit
None
NOTE:
1
Odd parity is only required if Port 3 is configured to TMAP at 38400 baud. If the port has changed from
either of these default settings, Parity should be set to None.
2
MPI WiFi Connection Settings
a
A WiFi connection to the WiFi module SSID must first be made on the PC.
Refer to Table 3022 and Figure 3008.
Table 3022. Tera Terminal WiFi Connection Settings
Setting
MPI Module
KGX WiFi Module
Host
192.168.10.1
192.168.5.1
TCP Port
44000
4000
Service
Other
Protocol
UNSPEC
3
Initial MPI Connection
a
Once connected to the MPI with a serial or WiFi connection, push the <Enter>
key three times to remove the maintenance lockout. The following prompt
must be displayed in the terminal window.
• KGX-150T> / KGX-130T> (KGX 150T/130T Transceivers) or
• KGX-150R> / KGX-130R> (KGX 150/130 Receivers).
EFFECTIVITY
ALL
Page 3019
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.