SYSTEM INSTALLATION MANUAL
89000016
INSTALLATION
1.
General
A.
Overview
(1)
This section provides installation information for the KGX 150/130, the optional KGX control
panel, and the optional KGX WiFi module. The equipment must be installed in the aircraft in a
manner consistent with acceptable workmanship and engineering practices, and in accordance
with the instructions set forth in this publication. To make sure that the system has been
properly and safely installed in the aircraft, the installer must make a thorough visual inspection
and conduct an overall operational check of the system, on the ground, prior to flight.
(2)
FAA AC 20-165A requires certified installations with ADS-B Out Transmitters (KGX 150/130
transceivers) and any transponder on the aircraft to transmit pressure altitude data obtained
from the same altitude sensor source. Installations must therefore make sure that the
transponder and KGX 150/130 transceivers receive altitude data from the same altitude sensor.
(3)
FAA AC 20-165A HIGHLY recommends that the ADS-B transmitter and transponder share a
single point of entry for Mode A (squawk mode) and IDENT. Dual entry installations are
allowed but discouraged and must make sure that the transponder and UAT transmit the same
Mode A and IDENT without increased pilot workload. Transponders with serial control data
out capability must be connected through a KGX 150/130 transceiver serial port to control
Mode A code and IDENT. Mode A/C transponders without serial control data out can use the
KGX 150/130 transceiver internal Mode A receiver (configuration setting) which receives the
on-board transponder transmissions to automatically set Mode A code and IDENT control data
transmit. Mode A receive is not compatible with Mode S transponders.
(4)
KGX 150R/130R require pressure altitude input but are not required to use the same pressure
altitude input as the transponder.
2.
Unpacking and Inspecting Equipment
A.
General
(1)
Exercise care when unpacking each item. Visually inspect each item for evidence of damage
incurred during shipment. If a damage claim must be filed, save the shipping container to
substantiate the claim. When all equipment and the installation kit have been inspected,
save the packing material and container in case the unit is to be stored or reshipped. Refer
to Paragraph 3 of the GENERAL INFORMATION section for equipment and optional parts
supplied.
3.
Parts and Equipment
A.
KGX Items
(1)
The KGX and optional equipment part numbers are listed in Table 1001.
Table 1001. KGX and Optional Equipment Part Numbers
PN
Qty
Description
89000016-130
1
KGX 130T ADS-B transceiver with no internal GPS
89000016-131
1
KGX 130R ADS-B receiver with no internal GPS
89000016-150
1
KGX 150R ADS-B receiver with integrated WAAS GPS
89000016-151
1
KGX 150T ADS-B transceiver with integrated WAAS GPS
EFFECTIVITY
ALL
Page 1001
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.