Bender ATICS Series, Manual

Page: 92 / 104

92 ATICS-DIO_D00080_03_M_XXEN / 04.2021
Periodic verification and service
9.5.1 Removing the existing ATICS®
i
Description applies to ATICS-…-DIO.
1. Record settings on the existing ATICS®. The settings should match the entries in the checklist
(see checklist, included in the scope of delivery).
2. Disconnect the device from the power supply or switch on the bypass switch. Switch existing
ATICS® to manual operation, switch to position "0" and secure against unintentional switch-
on (see chapter „Connecting the ATICS® safely“ on p. 31).
3. Remove connections
4. Remove the ATICS®
ATICS-2-DIO
: Undo the mounting screws on the top green
plug connector and remove the connector (A). ATICS-4-DIO :
Undo the mounting screws of the upper green plug connec-
tors and remove the two plug connectors.
Afterwards, loosen the fastening screws of the bottom green
plug connector and remove the connector (B).
Remove the three connector plugs (C).
C
A
B
N N