Bender ATICS Series, Manual

Page: 69 / 104

ATICS-DIO_D00080_03_M_XXEN / 04.2021 69
ATICS-…-DIO
Menu item Function
10. Serviceinterv. Service interval:
Setting range:
off, 6…48 months
Resolution of setting: 6 months
11. Reminder Warning time for service interval (d=day):
Setting range:
off, 1…60 days
Resolution of setting: 1 day
12. t (GenStart) Time delay for changeover to generator (measured from "Voltage line 2 = OK"):
Setting range:
0 s…100 s (only active when System=Line G)
Resolution of settings: 1 s / 5 s
13. t(GenMax) Maximum generator start time. Monitoring whether the generator starts (time until
"Voltage line 2 = OK").
Setting range:
0 s…100 s (only active when System=Line G)
Resolution of setting: 1 s / 5 s
14. t(Gen.off) Time delay for turning off the generator after switching back to
the preferred line:
Setting range:
2 s…180 min (only active when System=Line G)
Resolution of setting: 1 s / 5 s / 1 min
7.3.4.2 Settings menu 2: Voltage
In this menu you can make settings for voltage monitoring on line 1 and line 2 individually or together.
Example: Line 1 is set to "Undervolt: 184 V". If the voltage on line 1 falls below 184 V, the device
displays an alarm message. If the voltage on line 2 is within the set range, a changeover to
line 2 takes place. The ATICS® returns to line 1 if the voltage on line 1 exceeds the pre-set
value (in this case 184 V) plus the set hysteresis.
Selecting a line:
1. Use the " " arrow button to go to the line setting. Press the " " button.
2. Use the arrow buttons to select one line (voltage 1, 2) or both lines (voltage 1…2).
Press the " " button to confirm your selection.
Setting voltage for one line Setting voltage for both lines
Voltage: 1 . . 2
Exit
1. Undervolt.:
184V
2. Overvoltage: 250V
Voltage: 2
Exit
1. Undervolt.:
184V
2. Overvoltage. 250V