Bender ATICS Series, Manual

Page: 9 / 104

ATICS-DIO_D00080_03_M_XXEN / 04.2021 9
ATICS-…-DIO
Before installing and connecting the device, make sure that the installation has been de-energised.
Observe the rules for working on electrical installations.
1.9 General safety instructions
Bender devices are designed and built in accordance with the state of the art and accepted rules in re-
spect of technical safety. However, the use of such devices may introduce risks to the life and limb of
the user or third parties and/or result in damage to Bender devices or other property.
• Use Bender devices only:
– as intended
– in perfect working order
– in compliance with the accident prevention regulations and guidelines applicable at the location
of use
• Eliminate all faults immediately which may endanger safety.
• The device may not be opened.
• Do not make any unauthorised changes and only use replacement parts and optional acces-
sories purchased from or recommended by the manufacturer of the devices. Failure to ob-
serve this requirement can result in fire, electric shock and injury.
• Reference signs must always be clearly legible. Replace damaged or illegible signs immedi-
ately.
• Make sure that the dimensions of the BSV (battery-supported safety power supply), the gen-
erator set and the whole wiring is adequate. Abide by the relevant, applicable national and
international standards. In the event of an overload and short circuit, this is the only way to
guarantee the necessary safety and to ensure that the safety devices respond selectively.
• If the device is overloaded by overvoltage or a short-circuit current load, it must be checked
and replaced if necessary.
• The overvoltage protective device required by the standards VDE 0100-443 and VDE 0100-
534 must be installed in the electrical installation or system.
1.10 Device-specific safety instructions
I
W
arning
!
Failure to adjust the settings may result in malfunction.
The settings must be changed in order to adapt the ATICS® automatic transfer switching device to
the existing equipment. When doing so, follow the instructions chapter „Design and Installation“ on
p. 43.
I
W
arning
!
Functional safety according to IEC 61508 can only be guaranteed when used properly.
Please follow the instructions given in this operating manual and in the check list.