Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
Donut Robot Mark II / Mark V TS
MN-1013EN
15
THE CONVEYOR BITES THE DONUTS.
Possible Causes
What To Do
The donuts are not cooking enough.
See “The donuts are undercooked” below.
The shortening level is too low.
Add shortening to reach the proper level.
WARNING
Before doing any of the following, turn off the
machine and allow the shortening to cool.
The turner is bent or packed with cooked food
particles.
Straighten and/or clean the turner.
The cam weight is sticking due to the
accumulation of varnish.
Clean to remove the cooked-on varnish.
The fryer is not level.
Level the fryer.
THE DEPOSITOR OPERATES CONTINUOUSLY.
Possible Causes
What To Do
WARNING
To avoid being burned, electrocuted, or otherwise
injured, before doing any of the following, turn
off the machine, allow the shortening to cool, and
disconnect the machine from the power source.
One of the microswitches is defective. (There
are three microswitches in the conveyor drive
assembly and one microswitch in the depositor.)
For help in testing the microswitches, refer to the
section “Electrical Components.” Replace any
defective microswitches.
Something is interfering with the nylon brake
dog in the depositor.
Clear away the cause of the interference.
The brake spring in the depositor is weak or
broken.
Replace the spring.
