Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
8
MN-1012EN
Donut Robot Mark II / Mark V OM
NOTE
If the Power light is on but the
Temperature Controller fails to turn on,
the high temperature limit control could be
tripped. Push the red reset button on the
back bottom of the heater head.
Making Cake Donuts
1.
If not already in place, install the swing
column, install the depositor’s cutter head,
and install the hopper and the plunger.
2.
Swing the hopper away from the fryer so it
is not directly above the fryer.
a.
It may be necessary to disengage the
swing connecting rod from the swing
column throw arm.
3.
Adjust the size selector dial on the
depositor’s crankshaft assembly. This dial
regulates the donut weight. The higher the
setting, the larger the donuts will be. Adjust
the dial setting as follows:
a.
Unscrew the dial lock nut 1/2 turn.
b.
Turn the dial to the desired position, as
indicated by the marks on the crank
plate.
c.
Tighten the dial in place with the lock
nut. Tighten it using your fingers
only.
4.
Put batter into the hopper. ‘PRIME’ the
hopper to expel any air that may be trapped
in the bottom of hopper. To prime the
hopper:
a.
Hold a mixing bowl or other
receptacle under the depositor hopper.
b.
Hold DOWN the switch on the
depositor until it has dropped two or
three donuts into the bowl.
NOTE
Holding down the prime switch causes the
depositor to run continuously without the
normal delay between cuts.
c.
Put the batter in the bowl back into
the hopper.
5.
Return the hopper into position over the
fryer and reconnect the swing connecting
rod to the swing column throw arm.
6.
Turn the
FRY TIME
dial to adjust the
fry time to the desired speed.
7.
For 2 donuts (or 4 mini donuts) per row, set
the
Feed table/Cake Donut depositor
switch to
CAKE DONUT DEPOSITOR
.
For 1 donut (or 2 mini donuts) per row, set
the switch to
FEED TABLE
.
8.
Turn on the cake donut depositor by pushing
UP the switch on the depositor.
9.
Set
FRYER CONVEYOR
switch to
AUTO
.
NOTE
If the conveyor becomes jammed, a
warning buzzer will sound about a minute
later and stop when the conveyor is turned
off. The conveyor drive motor is impedance-
protected so it will not burn out due to
jamming.
WARNING
If the conveyor becomes jammed:
1. Turn off the conveyor drive and the heater.
2. Allow the system to cool down.
HOT SHORTENING IS DANGEROUS.
3. Determine the cause of the jamming.
4. Clear it.
5. Restart the system.
1.
Continue adding shortening to the kettle to
maintain the proper shortening level (level
chain).
2.
Continue adding batter to the hopper as
needed.
a.
You can add batter to the hopper
without priming it again as long as it
does not become empty.
4
5
3
