Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
18
MN-1012EN
Donut Robot Mark II / Mark V OM
Filter Flo Siphon
Figure 9 Filter Flo Siphon.
The Filter Flo Siphon is designed to drain and
filter shortening from the kettle of the Donut
Robot. The operator is expected to read and
follow these instructions.
Installation
1. Let the shortening cool to 100
°
F/38
°
C.
WARNING
Hot shortening can cause serious burns.
Never touch hot shortening. Never wear
shorts while using the Filter Flo Siphon.
2. Place the mounting bracket, with the siphon
tube in it, on the lip of the kettle. You may
place it on the infeed end of the kettle, or on
the front side of the kettle. If you place it on
the front side, you must disconnect the
swing connecting rod from the throw arm
and move it out of the way.
3. Position the opening of the siphon tube near
the bottom of the kettle.
4. Tighten the thumb screw in the mounting
bracket.
5. Attach the filter assembly to the lower part
of the siphon tube, as shown in Figure 11.
To do this:
a. Slide the opening in the filter mounting
bracket around the siphon tube.
b. Adjust the filter mounting bracket
vertically to ensure that the filter does
not touch the valve assembly.
c. Tighten the screw that holds the filter
mounting bracket to the siphon tube.
d. Tighten the screw that holds the filter
retaining ring to the filter mounting
bracket.
WARNING
Make sure that both screw in the filter
assembly are tight. If they are not, the
filter assembly might slide off of the siphon
tube during operation, causing shortening
to splatter.
6. Place a five-gallon metal container under the
filter.
Bulb
Mounting Bracket
Handle
Siphon Tube
Filter
