Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
8
MN-1012EN
Donut Robot Mark II / Mark V TS
Adjusting the Hopper
Read this section only if you are preparing to
make cake donuts.
WARNING
To avoid injury, always disconnect the
machine from the power source before
making adjustments.
1. The bottom of the hopper should be 1”/
2.5 cm above the flight bars. To set the
height of the hopper:
a. Hold the depositor from below to
prevent from dropping suddenly.
b. Loosen the set screw in the lower set
collar on the swing column.
c. Raise or lower the swing column as
needed.
d. Tighten the setscrew. (See Figure 1-8.)
Figure 1-8. Adjusting the Height of the
Hopper.
2. As the hopper swings back and forth over
the kettle, the hopper cylinder should stop
the same distance away from either side of
the kettle at each end of the swing.
To check the swing of the hopper, turn on
the conveyor. If you need to center the
swing of the hopper, follow these steps:
a. Turn off the conveyor.
b. Loosen the setscrews in the upper set
collar.
c. Swivel the depositor as needed.
d. Tighten the setscrews. See Figure 1-9.
Figure 1-9. Adjusting the Swing of the
Hopper.
e. Double-check the swing of the hopper by
turning on the conveyor. Then turn off
the conveyor.
