Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
Donut Robot Mark II / Mark V OM
MN-1012EN
13
6.
Lift out the turner. See Figure 4.
Figure 4 Removing the Turner
7.
Wash the turner cam and turner using mild
detergent and warm water.
12.
Rinse the turner cam and turner in clear
water.
13.
Dry thoroughly.
WARNING
All parts must be dried thoroughly.
Moisture causes hot shortening to
spatter, which may cause serious injury.
14.
To clean the drop plate, remove it by lifting
its forward end and sliding it toward the rear
of the conveyor. (See Figure 5) Wipe the
drop plate with a damp cloth.
CAUTION
If the drop plate is scratched, donuts will
stick to it. To prevent this from happening,
always wipe the drop plate in the direction
of the grain in the metal, which runs
parallel to the length of the conveyor, and
never use abrasive cleaners.
Figure 5 Removing the Drop Plate
15.
Brush off any carbon that has accumulated
on the Donut Robot’s heating element.
Accumulated carbon can cause corrosion
and ineffective heating.
16.
Tilt the heater head assembly back, raising
the heating element out of the kettle.
17.
Lift the kettle out of the fryer case.
18.
Clean all parts of the kettle if needed, inside
and out.
19.
Ensure all parts are dry
20.
Replace the kettle and lower the heater head.
21.
Put the drop plate, turner cam, and turner
back on the conveyor.
22.
Replace the conveyor
a.
When you replace the conveyor, line up
the notch in the drive coupling with the
large bolt in the motor drive (at the right
end of the heater head).
