Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
Donut Robot Mark II / Mark V TS
MN-1013EN
5
Unpacking the Fryer
1.
Remove the foam and other packing
materials from the two boxes.
2.
Remove the fryer and move it onto its
supporting surface. Two people are required
to move the fryer. If you must move the
fryer by yourself, perform these steps:
3.
Remove the conveyor from the fryer.
4.
Remove the retaining pins that hold the
heater head in place, and lift the heater head
out of the fryer. Set the heater head gently in
a secure place.
5.
Remove the fryer case and kettle, and move
them to the work location. Take care not to
drag the electrical cord along the floor, in
case you may trip.
6.
Remove the cutter head of the depositor.
Take care not to drag the electrical cord
along the floor, in case you may trip.
7.
Remove the hopper, plunger, and column.
Initial Cleaning
Thoroughly clean your Donut Robot before using
it. Remove all packing materials. Use
household dishwashing detergent.
Do not use
strong alkali cleaners such as lye, soda ash, or
trisodium phosphate
. Thoroughly dry and
lubricate parts to prevent rusting.
Refer to the ‘Cleaning’ section in the Operator's
Manual for cleaning instructions.
WARNING
To avoid electrocution or damaging the
machine, never allow water, steam,
cleaning solution, or other liquid to enter
the cutter head or fryer heater head
compartments.
WARNING
Never let water and hot shortening come in
contact. Moisture causes hot shortening to
spatter, which may cause serious injury.
Prior to use, make sure any parts you have
washed are dry.
After cleaning, assemble the fryer and depositor
as explained below.
Assembling the Fryer
1. Place the fryer case on a flat, stationary
surface.
2. Screw the fryer’s legs in as far as they will
go.
3. Set the kettle into the fryer case. The end of
the kettle that has the locating pin must be
placed at the outfeed end of the fryer case.
The lip of the kettle should fit securely over
the edge of the case.
4. Install the heater head assembly as follows:
a. Align the holes in the heater head end
caps with the holes in the heater head
mounting brackets.
b. Slide the retaining pins through the holes
so that the pinheads are on the outside.
c. Insert the hairpin clips into the holes in
the retaining pins.
5.
Lower the heater head assembly into
position. The thermostat bulb bracket should
rest on or very near the bottom of the kettle.
6. Install the conveyor assembly as follows:
a. Hold the conveyor at the angle shown in
Figure 1-2 and slide the conveyor drive
coupling over the main drive shaft
coupling. The conveyor coupling has a
notch in it. Turn the conveyor coupling
so that the head of the socket head screw
in the motor drive coupling can slide into
this notch. (See Figure 1-2.)
