22
Multiviewer Cabling
Rear Connector Panel
• One RJ-45 for data transfer over Ethernet.
With the double-width rear panel installed in a Densité-3 frame, the KMV-3901/3911 must
be installed in the rightmost of the two slots covered by the panel in order to mate with the
panel’s connectors.
In a Densité 3 mini frame, the card must be placed in the bottom slot.
If it is placed in the wrong slot, the front panel LED will flash red. Move the card to the other
slot for correct operation. No damage will result to the card if this occurs.
KMV-3911-8X2-3DRP rear panel
KMV-3901-8X2-3DRP rear panel
Ethernet Port
The Ethernet port must be configured before it can be used to communicate with the KMV-
3901/3911. See
GPI/RS-422 Connector
The DB-26 GPI connector carries 8 GPI IN and 2 GPI OUT lines, plus the RS-422 interface. The
pinout of this connector is listed below.
:
Pin
Function
Pin
Function
Pin
Function
1
422 TX+
10
422 TX -
19
GND
2
422 RX+
11
422 RX -
20
GND
3
GPI IN2
12
GPI IN1
21
GPI IN3
4
GND
13
GPI IN4
22
GPI IN5
5
GPI IN7
14
GPI IN6
23
GPI IN8
6
NC
15
GND
24
NC
7
OUT 1-(emitter)
16
GND
25
OUT 1+ (collector)
8
GND
17
GND
26
OUT 2- (emitter)
9
NC
18
OUT 2+ (collector)
