91
KMV-3901/KMV-3911
Installation & Service Manual
All devices, and Kaleido multiviewer rooms, detected by the RCP-200 appear on the left
screen. Kaleido multiviewer rooms are listed in the form [multiviewer name]\[room
name].
If a room belongs to a cluster system, its name appears once for each of the member
multiviewers (e.g., if two multiviewers, KX1 and KX2, are configured as a cluster, and
ROOM1 includes displays fed by both multiviewers, then both KX1\ROOM1 and
KX2\ROOM1 will be listed. To determine the one you should select, review the
following:
• Has the RCP user configuration you want to use been replicated on every member
of the cluster? RCP Users are not automatically propagated to all multiviewers.
Before a user can log on to a room associated with a cluster system, the
corresponding RCP user configuration must be manually replicated on all member
multiviewers across the cluster. See
Managing RCP Users
in the Kaleido Software
User Guide.
• Do you need to control an external router whose configuration is available only
from one or some specific members of the cluster?
• Does your system configuration include actions that were configured only on one
or some specific members of the cluster?
• Do you need to control a timer from the monitor wall in a cascade room?
If any of the above elements is available only from one or some specific members, then
make sure you select the room name prefixed with the appropriate multiviewer name.
In the case of a cascade room, unless you remember which multiviewer you were
connected to when you added the timer you need to control, you will have to proceed
by trial and error.
2 Touch the room you want to access (press the DOWN or UP soft keys to scroll the list as
needed).
The list of users assigned to this room appears on the right-hand screen.
3 Touch the user name under which you want to log on, enter your password, and then
touch LOG IN.
The following message appears on the right-hand screen: PLEASE SELECT A ROUTER
FROM THE LEFT-HAND SCREEN, prefixed with the name of the multiviewer that
appeared before the room name you selected in
.
4 In the list on the left-hand screen, touch the
KX Router
logical router associated with the
same multiviewer (you can see the multiviewer name, its IP address, and the size of that
particular KX Router).
5 Touch the Video level, in the area to the right of the router list, if it is not selected
already, and then push SELECT.
The room’s monitor wall control panel appears on the right-hand screen, with the
ASSIGN CHANNEL category selected. If a mouse is connected to the RCP-200, then after
touching WALL MOUSE you should be able to see and move the mouse pointer on the
monitor wall.
• If the room you selected belongs to a
cascade
system, touch a monitor showing a
source you can identify as coming from a different multiviewer than the one indicated
Note:
By default, the user “Admin” has no password.
