H2AIR
®
ARCH
4
Belanger, Inc.® *PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
1MANUL958
Operational Warning
Formulations containing the chemicals listed below are particularly dangerous and
should not be
used
even at low concentrations:
Hydrofluoric Acid
Ammonium Bi-fluoride
Bromic Acid
Muriatic Acid
Sulfonic Acid
Phosphoric Acid
Hydrogen Cyanide
Hydrochloric Acid
Chlorinated Solvents
Belanger, Inc.®, does not endorse or condone the use of chemicals that are potentially dangerous to human health, the
environment or property. Belanger® recognizes that it is the right and sole decision of the end user operators of our
equipment as to the type and dilution ratio of the chemicals used in their facilities. We strongly recommend that the end
user does not select products containing any of the chemicals listed above as an ingredient in the wash solutions. The
chemicals listed above are potentially dangerous to human health, and have a detrimental, deteriorating effect on the
equipment and the facility. Be advised that a portion of, or all of your warranty will be voided if you determine to use any of
the chemicals listed above as an ingredient in the wash solutions in conjunction with your Belanger® automatic car wash
equipment:
Limitation (4), of Paragraph (8), Limited Warranty, of the Belanger® Terms and Conditions of Sales describes the
potential limitation of warranty due to your chemical selection:
(4) This warranty shall be void for all equipment failures and premature component wear caused by the use of
corrosive chemicals in the wash process. The following list includes some, but not all, of the particularly corrosive
chemicals that if used in conjunction with Belanger® equipment will void the warranty: Hydrofluoric Acid, Ammonium
Bi-fluoride, Bromic Acid, Muriatic Acid, Sulfonic Acid, Phosphoric Acid, Hydrogen Cyanide, Hydrochloric Acid, and
Chlorinated Solvents. The Purchaser also agrees to accept the responsibility and liability for the selection and use of
any chemicals listed above;
However, should the end user decide to use formulations containing any of the above ingredients, the end user should
institute a comprehensive training program and implement detailed operational parameters within their organization for the
proper handling and treatment of such products to minimize the potential dangers involved. Consult your chemical supplier
for assistance in establishing operational guidelines in the use of their products. MSDS (Material Safety Data Sheet) should
be obtained from the chemical supplier before using any chemical formulation.
CAUTION
During the installation process the installer is responsible for re-tightening ALL
lugs, set screws and terminals located in the electrical panels. Components may
vibrate loose during shipping.
