Beijer Electronics Frequency Inverter BFI-P2
KI00306B 2020-03
www.beijer.se www.beijer.no www.beijer.dk
www.beijerelectronics.com www.beijerelectronics.de www.beijerelektronik.com.tr
26 (31)
IP20 Run motor from keypad
Set parameter P1-12=1
Connect the safety digital inputs correctly, terminal 9 to 13 and terminal 1 to 12
Enable drive by closing the switch between control terminals 1 & 2. Display will show Stop.
Press the key. The display shows
.
or latest frequency before stop.
Press to increase speed.
The drive will run forward, increasing speed until is released.
The rate of acceleration is controlled by the setting of P1-03, check this before
starting.
Press to decrease speed. The drive will decrease speed until is released. The rate of
deceleration is limited by the setting in P1-04
Press the key. The drive will decelerate to rest at the rate set in P1-04.
The display will finally show Stop at which point the drive is disabled
To preset a target speed prior to enable, press the key whilst the drive is stopped. The display
will show the target speed, use the & keys to adjust as required then press the key.
Pressing the key will start the drive accelerating to the target speed.
To allow the drive to be controlled from keypad in a forward and reverse direction, set P1-12 =2.
Press the key. The display changes to
.
.
Press to increase speed
The drive will run forward, increasing speed until is released.
To reverse the direction of rotation of the motor, press the key again.
6.12 Monitoring from Keypad
Parameter group 0 contain variables to be monitors as table below:
