Appendix
CX8050, CX8051 - Embedded-PCs for
CANopen and CAN
136
Version: 1.4
9. The host name is composed by default of "CX" and the last 3 bytes of the MAC address. You can find the
MAC address on the side of the CX80xx. The MAC address is always 6 bytes long and the first three bytes
are the vendor ID, which is always 00 01 05 in the case of Beckhoff devices.
An "X" next to
Connected
means that the CX is already known in the system and can be used. To make it
known, click in the list on the CX with which you want to connect and then click on "Add route". An input
mask opens with "User name" and "Password". By default there is no password, simply confirm by clicking
on OK. Afterwards the "X" should appear next to
connected
.
10. Next, the CX should appear in the list of the devices; select it and confirm by clicking on OK.
11. Check whether the connection is there. In the System Manager in the bottom right-hand corner. It must
be blue or green and may
not
be yellow.
12. If the setting is green, switch the CX to Config Mode with "Shift F4" or click on the blue TC icon in the
System Manager. The System Manager now asks you whether you really want to switch to Config Mode;
confirm by clicking on OK.
13. The setting at the bottom right must now change to blue and the TC LED on the CX80xx must now also
light up blue.
14. Now click on I/O Devices and then on Scan Devices...
15. A message appears, informing you that not everything will be automatically detected.
16. The CCAT interface is usually found (CX8090) or the corresponding fieldbus interface (other CX80xx
devices) and either a K-bus interface or an EtherCAT interface, depending now on which terminals you have
connected to the CX. The CCAT interface must be present in the System Manager file and may not be
deleted. If an error message should appear when scanning, check the revision level of your TwinCAT
version and perform an update if necessary.
Summary of Contents for CX8050
Page 2: ......
