BayStream 7.3 Documentation Change Notice
6
BayStream Multiservice Software Version 7.3
115385-D Rev 01
Configuring and Managing the File System
You can use the Technician Interface and Site Manager to configure a VFS.
Using the Technician Interface
Perform the following steps:
1.
Use the Technician Interface set command to create a VFS volume for a
specific slot.
Figure 1
shows an example of a set command that creates a VFS
volume in Slot 1.
2.
Use the set command to specify the size of the volume.
Figure 2
shows an
example of a set command that sets the file size in Slot 1 to 500000 bytes.
Figure 1.
Creating a VFS Volume
Figure 2.
Setting the Size of a VFS Volume
Use the Technician Interface commands shown in
Table 3
to manage the VFS
volume.
[4:1] $ set wfFrSwExtFileSysEntry.1.1 1
BYS0089A
TI set command
NVFS/DRAM file
system MIB entry
Attribute identifier (1=wfFrSwExtFileSysDelete)
Slot number
Value (1=create)
[4:1] $ set wfFrSwExtFileSysEntry.3.1 500000
BYS0090A
TI set command
NVFS/DRAM file
system MIB entry
Attribute identifier (3=wfFrSwExtFileSysSize)
Slot number
Value (memory
in bytes)
