Bay Networks 5391, Installation Manual, Page: 85 / 114

5-15
Chapter 5 Configuration Examples
Installing Remote Annex Network Software for Windows
Setting Up PRI Channels
This example shows how to configure a Remote Annex 6300 to handle
dial-in calls from ISDN and analog modems.
Before You Begin
Before you configure the RA6300 using Quick2Config Annex:
1. Verify that the Annex is configured to boot from a host with a
valid Annex configuration file.
Self-boot units will not allow you to modify the
configuration file, which may be necessary in some of the
following steps. You must manually edit the configuration
file for a self-boot unit and then reboot the unit in order
to allow some changes.
2. At the host system, use NA to set the Annex to allow parameters
to be set via SNMP.
%na
command:annex 129.9.200.62
command:set annex allow_snmp_sets y
3. Set the switch type to att or dms to match the type of your PRI
line.
command: set pri switch_type att
4. Specify the distance between your RA6300 and the CSU by
selecting one of the following ranges: 0-25, 26-65, 66-100, 136-
185, 186-210.
command: set pri dsx1_line_length 0-25
The default is 0-25.