Bavarian RC Messerschmitt Me-410
© 2021 BAVARIAN RC. Plans and instructions provided free of charge. Copies allowed for personal use only. Not for commercial use.
-
55 -
Version Beta 1.0
-
Take 3x nylon screws M6. The fwd screw has a length of 45mm. The two aft screws have a
length of 30mm.
-
Put the six Foam board pile for the wing mount (front) on top of each other.
-
Insert the pile into the fwd cavity of the wing and insert the fwd nylon screw from the
bottom.
-
Put the two Foam board pile for the wing mount (aft) on top of each other.
-
Insert the pile into the aft cavity of the wing and insert the two aft nylon screws from the
bottom.
-
Test fit the wing on the fuselage and then tighten the screws.
-
Check if you have a good fit between the fuselage and the wing and adjust if necessary the
wing cut-out.
-
Also check if the foam board pile thickness is OK. The upper side of the pile should be in
contact with the plywood part of the wing mount inside the fuselage. You might have to
adjust by adding or removing a layer or using thin balsa wood layers until the thickness is OK.