O&M Manual for PowerKit
M26 Series Diesel Engine
50
Check the fuel level
Check the fuel level with fuel meter
or fuel gauge, which is installed in
the side of the fuel tank.
If the fuel is not enough, add fuel
through fuel filler to fill the tank.
CAUTION
When adding fuel, never allow fuel
overflow as this may cause a fire. If any
fuel is spilled, wipe it up completely.
Never bring flames near fuel because it
is highly flammable and dangerous.
Open hood.
Remove dipstick and wipe clean
with a lint-free cloth.
Insert dipstick until fully seated.
Remove dipstick and check oil
level at 3 mm below the H on the
dipstick.
If oil level is in L mark, add oil
through oil cap 1 as necessary.
CAUTION:
Check engine oil level with engine
cold
.
If oil level is below minimum mark,
DO
NOT
start the engine. After engine
stopped, wait at least 5 minutes before
checking the oil level.
Check the fuel water separator
Check the water collecting vessel 1,
draining water as follows:
Open the Drain Plug 2 at bottom of
water collecting vessel 1 and drain
any water.
Retighten up the water drain plug
2.
Summary of Contents for 12M26 Series
