Barco ImagePRO, User Manual

Page: 16 / 126

R5906167 /00 ImagePRO – 4K Video Processor
16
Menu
A scrollable list of options available on the front-panel display or the EMTS GUI.
National Television Standards Committee (NTSC)
The oldest standard for color picture broadcasting. NTSC is a standard definition format that operates at a
frequency of 59.94Hz, with 525 lines, 59.94 fields and 29.97 frames per second.
Phase Alternating Line (PAL)
PAL is the predominant TV standard in Europe. PAL is a standard definition format that operates at a
frequency of 50Hz, with 625 lines, 50 fields, and 25 frames per second.
RGB
A color space that represents color as the red, green, and blue color signal components.
Serial Digital Interface (SDI)
SDI is a serial link standardized by the Society of Motion Picture and Television Engineers (SMPTE). SDI
transmits uncompressed digital video over 75-ohm coaxial cable within studios, and is seen on most
professional video infrastructure equipment.
Society of Motion Picture and Television Engineers (SMPTE)
A professional association that develops and publishes video-related standards.
YCbCr
A color space that represents color as brightness and two color difference signals. Y is the brightness (luma),
Cb is the blue-difference (blue minus luma: B-Y) and Cr is the red-difference (red minus luma: R-Y).
3.4 Unpacking and inspection
General
Before shipment, all the devices were inspected and found to be free of mechanical and electrical defects. As
soon as the devices are unpacked, inspect for any damage that may have occurred in transit. Save all packing
material until the inspection is completed. If damage is found, file claim with carrier immediately. The Barco
Sales and the Service office should be notified as soon as possible.
Unpacking
At delivery, Event Master devices are packed in a shipping case. Place the shipping case of the device on a
stable (solid), flat and insulated support during all the unpacking. Open the case from the top. Remove the
device that is packaged in an antistatic bag. Check the box content after unpacking.
After unpacking let the device acclimate to the room temperature which must be higher than 0°C
(32°F) and lower than 40°C (104°F). Neglecting this may result in startup failure of the device.
When shipping an ImagePRO – 4K video processor in a Barco-supplied case, make sure that the
rear connector protectors are installed to prevent damage.
Save the original shipping case and packing material, these will be necessary if you ever have to
ship your device. For maximum protection, repack your device as it was originally packed at the
factory.
Box content
After unpacking an ImagePRO – 4K device, it is recommended that it be checked to see if all accessories were
included. The following accessories should be included.
General