11. Convergence
11.2 Preparing for convergence adjustment
Necessary tools
•
7mm
fl
at screwdriver.
•
3mm Allen wrench.
How to set up the projector for convergence adjustment?
1. Remove the top cover from of the projector. See procedures page 120.
2. Remove the left side cover from of the projector. See procedures page 121.
3. Remove the top cover plate of the Light Processor compartment. See page 122.
4. Remove the left cover plate of the Light Processor compartment. See page 124.
5. Place the fan on top of the Light Processor in the upper position as illustrated. Do this by engaging the two lower slots (reference
2 image 11-3) into the upper mounting pins as illustrated. The two upper slots (reference 3 image 11-3) remains free.
3
2
Image 11-3
6. Switch on the projector, ignite the lamp and open the dowser. See "Switching the DP2K-S series projector ON", page 54.
7. Select the convergence test pattern, which is illustrated below (image 11-4). Use the communicator to activate the convergence
test pattern.
Note:
The convergence test pattern can NOT be activated via the
PATTERN
button on the Local Keypad.
4
1
2
5
3
6
Image 11-4
70
R5977692 DP2K-S SERIES 10/12/2012
Summary of Contents for DP2K-S Series
