Barco DP2K-S Series, User And Installation Manual

Page: 85 / 153

12. Lamp House & Lamp replacement
12.3 Lamp replacement process
About this process
This process enumerates all procedures in a chronological order for replacement of the xenon lamp of the projector. The stages in
this process refer to the detailed step by step procedures included in this document.
Lamp replacement process from A to Z
1. Put the projector in standby mode, wait 15 minutes to let the projector cool down (after cooling), and then switch off the projector.
15min
Image 12-5
2. Remove the cover of the Lamp House compartment. See page 118.
Image 12-6
3. Remove the Lamp House from the projector. See page 83.
Image 12-7
4. Remove the exhausted xenon lamp from the Lamp House. See page 89.
Image 12-8
5. Perform maintenance actions for lamp replacement. See page 104.
6. Install a new xenon lamp in the Lamp House. See page 89.
R5977692 DP2K-S SERIES 10/12/2012 81