Barco DP2K-S Series, User And Installation Manual

Page: 87 / 153

12. Lamp House & Lamp replacement
12.4 Removal of the Lamp House
W
ARNING
:
This procedure may only be performed by quali fi ed technical service personnel.
W
ARNING
:
The Lamp House is very hot after operation. To avoid burns, let the projector cool down for at
least 15 minutes before proceeding to remove the Lamp House.
C
AUTION
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
handled.
Necessary tools
8mm nut driver or fl at screw driver.
How to remove the Lamp House from the projector?
1. Ensure the projector is switched off and cooled down.
2. Remove the cover of the Lamp House compartment.
3. Release the two retaining screws (reference 1 image 12-14) at the base of the Lamp House. Use a 8mm nut driver or a fl at screw
driver.
4. Remove the Lamp House as follows:
a) Grip the Lamp House by the handle and slide it out half way of the lamp compartment
b) Support the Lamp House at the bottom with the other hand and remove it from the lamp compartment.
c) Place the Lamp House on a stable support.
Caution: Be aware of the weight of the lamp assembly. Take the necessary precautions to avoid personal injury.
1
Image 12-14
R5977692 DP2K-S SERIES 10/12/2012 83