Barco DP2K-S Series, User And Installation Manual

Page: 98 / 153

12. Lamp House & Lamp replacement
12.7 Installation of the Lamp House
W
ARNING
:
This procedure may only be performed by quali fi ed technical service personnel.
C
AUTION
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
handled.
Necessary tools
8mm nut driver or fl at screw driver.
How to install the Lamp House in the projector?
1. Check if the fi ve quarter turn screws turning wires (reference 1image 12-34) are fl ush with the cover or interference will occur
while inserting the Lamp House into the projector.
1
Image 12-34
2. Grip the Lamp House by the handle and place the front of the Lamp House onto the base plate guides inside the lamp compart-
ment of the projector, lining up the pins of the Lamp House with the slots on the base.
3. Push the Lamp House fully into the slots.
4. Secure the Lamp House by fastening the two retaining screws (reference 1 image 12-35) at the base of the Lamp House. Use
a 8mm nut driver or fl at screw driver.
5. Reinstall the cover of the Lamp House compartment.
1
Image 12-35
94 R5977692 DP2K-S SERIES 10/12/2012