DCS-200 • User’s Guide
31
3. Installation
Signal Installation
páÖå~ä=fåëí~ää~íáçå
The figure below illustrates a sample DCS-200 system. Use this figure for reference during
the signal installation process.
Figure 3-2.
DCS-200 System Diagram (sample)
Use the following steps to install signals to/from the DCS-200:
1. Input
connections
— any combination of inputs can be connected.
a.
As required, connect analog RGBHV sources to
Inputs 1
through
6
.
Refer to the “
” section on page 32 for a table
of analog input combinations.
b.
As required, connect DVI sources to
Inputs
7
and
8
(using the
connector’s digital pins).
c.
As required, connect analog sources to
Inputs
7
and
8
(using the
connector’s analog pins). A customer-supplied breakout cable or
DVI to
HD-15
adapter is required for this connection.
d.
As required, connect an HD-SDI or SD-SDI source to
Input 9
.
2. Output
connections
— up to three outputs can be connected:
a.
If you are connecting the DCS-200 to a digital projector (for example) or
other target device, connect the
DVI Output
to the projector’s DVI input.
b.
If you are connecting the DCS-200 to an analog projector (for example)
or other target device, connect the
Analog (HD-15) Output
to the
projector’s analog input.
c.
If you are connecting the DCS-200 to a Preview monitor, connect the
Preview DVI
or
Analog (HD-15) Output
to the monitor.
DCS-200
Inputs 1 - 6 (Analog)
Inputs 7 - 8 (DVI)
Input 9 (HD/SD SDI)
Sample Source Input
Devices
DVI
Analog
Program
Program
Ethernet
Serial
Preview
