Barco ClickShare, Service Manual

Page: 30 / 124

4. Product and components
Back layout of the Base Unit
At the back of the Base Unit you can fi nd the rocker switch, the label, the ports and connectors of the Base Unit.
1 2 3 4 5 6 7 8 9 10 1
Image 4-4
Backside of the Base Unit
1 Fixture points for the antenna
2 Label containing the article number and power rating of the product
3 Mains power connector
4 Rocker switch
5 DVI-I display connector
6 DisplayPort connector
7 LAN Ethernet connection
8 4 USB ports
9 Audio In port
10 Audio Out port
Rocker switch
The rocker switch is used to power on and off the Base Unit.
• To switch on the Base Unit, set the rocker switch to “I”.
• To shut down the system, set the rocker switch to “0”.
Mechanical fi xture points
The mechanical fi xture points are located at the bottom of the Base Unit
Antenna
Two antennas are included in the ClickShare box. To avoid damage during transport, they are not pre-mounted. Depending on the
installation method you should secure the antenna to the back of the Base Unit or to the front panel of the rack mount.
The antennas can rotate for a better wireless connection.
Usage of antennas other than the ones provided with the unit are allowed within the restrictions on usage of other antennas de fi ned
by local regulations. Barco does not take responsibility for damage or disturbance of other devices that may be caused by using a
different antenna. The use of an active power ampli
fi er is not allowed.
Antenna type : Dipole
Gain : Maximum 2dBi peak gain in 2.4GHz and 5Ghz band
Ventilation grids
Ventilation grids are foreseen on the top and both sides of the Base Unit.
18 R5900006 CLICKSHARE 04/12/2013