Barco ClickShare CSE-200+, Installation Manual

Page: 64 / 112

R5900087 /04 ClickShare CSE-200+ 64
When operational mode is set to Off . The following info is given: “ The wireless interface is disabled. Buttons
must be configured to connect to another Wi-Fi access point. Click here to go to the Button configuration
page ” .
Click on here to start the button configuration. For more info, see “ Buttons ” , page 91.
To change any WiFi-setting, click on Edit settings . The view depends on the previous selected operational
mode. Here given with Access Point selected.
Image 6-19: WiFi settings, edit
Changing the IP address will require a repairing of the Buttons used with this Base Unit.
Change operational mode
1. Log in to the Configurator .
2. Click Wi-Fi & Network → WiFi Settings .
3. Click Edit settings .
4. Click on the drop down box next to Operational Mode and select the desired mode.
The following options are possible:
• Access Point: continue with the next blocks in this topic.
• Wireless Client (only for CSE-200+): continue with “ WiFi settings, Wireless Client, EAP-TLS ” , page 67
• Off
About frequency band & channel selection
In an ideal setup, overlapping channels should not be used for two ClickShare Base Units within range of each
other. As the channels in the 2.4 GHz band overlap with each other, best practice is to use channels 1, 6 and
CSE-200+ Configurator