Baoli CPD10, Operation & Service Manual

Page: 15 / 124

10
(3) When the distance between the gravity center of loads and the fork arms is
500mm, the max. capacity is the rated capacity. When the distance exceeds 500mm, the
capacity shall be based on the load chart. Handle only loads within the allowable capacity
of the truck. The goods handled should not exceed the rated capacity of the truck.
(4) Operate your truck on a hard ground. Operate on other ground, the lift capacity
and travel speed must be decreased. Wipe off the oil and grease from the floor.
(5) Daily maintenance services should be done before or after using the truck.
Anytime you find that the truck is not functioning normally, operation of the truck should be
halted and check or repair at once.
(6) When operate one lever, pay attention not to shift another lever. Don’t operate the
lever at any position out of the driver seat.
(7) Do
n’t handle unfixed or loose goods. Be careful to handle bulky goods. To prevent
the collapse of stacked goods, tighten them. Forbid loading loose or little volume goods
without tray.
(8) If the truck is equipped with a load-handling attachment, its usage sphere will be
wider, but its allowable load and stability is reduced. The attachment and special device is
not to be diverted to any other purpose. It’s very dangerous to rebuild the attachment.
Please read the additional instruction we supplied and operate the truck following it
strictly.
(9) Fork can not be used to pull out any embedded goods, if necessary, the pulling
force should be estimated.
(10) Insert forks deeply under goods. Adjust fork’s distance according to the capacity
of goods. Make the loads distribute on the forks evenly to avoid tilt and slide of goods.
Don’t pick the loads with one fork tip.
(11) When handling bulky loads which restrict your vision, operate the forklift truck in
reverse or have a guide.
(12) When loading the goods, lower the forks to the floor. After the fork inserting
stacked goods, the fork arms should be in contact with the goods. Drive the truck with
mast tilting back for stabilizing the load. Before traveling, raise the forks for
200mm-300mm from the floor.
(13) While
mast’s lifting and lowering, anyone is absolutely prohibited from standing
under the lifting rack or being lifted with forks. Never permit anyone to stand or walk under
upraised forks.