Baoli CPD10, Operation & Service Manual

Page: 48 / 124

43
Fig. 2-27
(2) If the adjuster fails to do the above operation when the adjusting lever is pulled,
proceed with the following inspection:
a) Make sure that the adjusting lever, push rod, rod spring and the return spring for push
rod are securely installed.
b) Check the push rod return spring and adjuster spring for damage, and also check the
adjuster gear for rotating condition and meshing section for undue wear or damage.
Check if lever and gear is contacted. If above-mentioned condition occurs, replace the
damage parts with new ones.
2.2.5 Brake pedal adjustment (see Fig.2-28)
(1) Push the master cylinder lever.
(2) Adjust the pedal height with the stopper bolt, shown as Fig.2-28.
(3) With the brake pedal pressed and pull the rod out until its front end comes into contact
with the master cylinder piston.
(4) Tighten the push rod locking nut.
Fig. 2-28