Baoli CPD10, Operation & Service Manual

Page: 17 / 124

12
(27) Be careful and slowly driving over a dock board or bridge-plate.
(28) When travel with load, don’t tilt mast forward, don’t do handling. Don’t brake
abruptly to prevent the bulk from slipping off the forks.
(29) Drive the forklift truck to the stacked goods at a low speed, at the same time, pay
much attention to sharp and hard objects near the goods, otherwise, the tyres will be
pricked.
(30) Pay attention to pedestrian, obstacle and bumpy road when driving. Pay
attention to the clearance over the forklift truck.
(31) Keep your head, hands, arms, feet and
legs within the confines of the operator’s
compartment. Never allow other persons on the forklift truck.
(32) Crossing, turning and tilting shall not be taken on a slope. It could cause turning
sideways of the truck, it is very dangerous. On a slope, drive the truck with load forward to
ascend and backward to descend. When the truck goes down on a slope, drive slowly
with the brakes on. Make sure that the engine should not be shut down when traveling on
a slope.
(33) The starting, turning, driving, braking and stopping of the truck should be done
smoothly. When steering on the humid or slippery road, the truck should be decelerated.
(34) Operate the controls smoothly, don’t jerk the steering wheel. Avoid sudden stop,
acceleration, stop or turn. In the case of improper operation, the truck will turn over. In
case of this, the driver must keep calm, don’t jump off the truck. The driver must hold
tightly the control wheel with two hands; meanwhile, his body must incline in opposite
direction of truck’s turning
over.
(35) The unloaded forklift truck with attachment should be operated as a loaded
truck.
(36) Check the chains periodically to make sure that good lubrication condition exists
between the chain elements, the degree of tightness between left and right chain is
identical. If the variation value of the chain pitch exceeds 2% standard value, it indicates
that the chains have been worn excessively, replace it immediately.
(37) Before the truck decelerating and stopping, don’t put it into reverse gear, so as
to
ensure the safety of loading.
(38) Don’t make a sudden braking when the truck traveling with loads.
(39) When leaving, lower the forks on the ground and let the shift lever to neutral, cut
down the electric supply. If parking on a slope is unavoidable, apply the parking brake and