63
(1) Voltmeter
It indicates voltage of the battery. The single cell voltage must greater than 1.80V,
that is to say
, when the forklift truck with load, the voltage of 48V battery can’t be lower
than 43.2V, the voltage of 80V battery can’t be lower than 72V.
(2) Lamp switch & electric key (electric key not indicated in the diagram)
Pull the lamp switch to the first shift, the front and rear clearance lamps light. Pull the
switch to the second shift, the headlamps light while the front lamps and rear lamps keep
on. Turn the key switch clockwise to connect electric controller, the instrument circuit and
the electric circuit are ready for work.
(3) Error code display
When the electric controller is in trouble, a specific code displays, it can afford
serviceman fault information. To make a detailed diagnosis, please refer to the list of
alarm code. At the moment when the start switch is cut off, the alarm code on the left of
meter will show the working hours and disappear after several seconds.
(4) Signal of normal battery voltage
When turn off the key switch, this lamp lights, meaning working state is normal.
(5) Warning of under-voltage battery
The lamp lights when the battery is in a state of under-voltage, in the meantime, the
controlling power of lift switch (negative pole) is cut, the lifting is prohibited. The
under-voltage value of the battery (48V) is set on 40V. It means if the voltage is below 40V,
the value will be held for several seconds, the under-voltage protecting circuit comes into
play.
(6) Right turning signal (7) Brake signal
(8) Width indication
(9) Forward state signal
(10) Backward state signal
(11) Short signal
(12) Headlamp signal
(13) Left turning signal
(14) Electric controller hour meter (15) Working hour meter
4.6.2 Lighting signal
Include all kinds of illuminating lamps, signal lamps, horn and buzzer, etc.
Headlamp: 55W
Front combination lamp (turning/clearance): 10W/5W
Rear combination lamp (turning/clearance/backward/braking):
10W (red)/5W (red)/ 21W (white)/21W(red)
Warning lamp: 21W (optional)
Summary of Contents for CPD10
