Baoli CPD10, Operation & Service Manual

Page: 75 / 124

70
4.7.4
Process and
instruction of meter
(1) Turn on the key switch, some initial value mode will indicate for 3sec on the meter.
The mode helping operators judge the type of the forklift truck will indicate on the position
indicated speed, such as the four-wheel forklift truck is represented by CO. The
information about speed, electric energy, turning angle, hand brake, seat switch, E/S/H
selection and working hours is indicated on the meter, which help confirm the working
state.
(2) Alarm indication is on the first left line of the liquid crystal form, indicating three
working states when it lights up, as follows:
· Normally operating (When the system key is on or off, the lamp lights up)
· Meter is not connected to the controller (The lamp is on after this state remains for
3sec)
· Meter is not working (lamp lights)
No alarm code and the alarm indication lights off when the truck works normally.
(3) Move the turning switch forward and backward, the left and right turning signals
flash. When turn on the headlamp, lamp indication lights up.
(4) Brake indication
Operating the hand brake, indication as
○
,P lights up; pull the hand brake, the
signal turns off.
Note: When the electric quantity is below normal, that is to say the position of
the hand on the meter is down one form, please charge up the battery.
4.7.5 Working circumstance
(1) Elevation is lower than 1200 meters.
(2) Working temperature -25
℃
～
+40
℃
.
(3) Relative humidity is not larger than 95%.
4.7.6 Cautions
(1) Forbid wetting the meter. When washing the truck, don’t let water into the meter, if
it happens, clean it with dry cloth.
(2) Don’t
pull the plug of the meter and harness for the connection.
(3) Forbid impacting or scratching the meter strongly.
(4) When the meter works abnormally, contact with our company for maintenance.