Banner EZ-SCREEN SLS, Instruction Manual

Page: 37 / 114

May 22, 2023
EZ-SCREEN SLS Safety Light Curtain Instruction Manual
37
•
•
•
NOTE: If the Test input is open, the 3-digit Diagnostic Display indicates the total number of beams in the
system (minus one) and all Zone indicators are red.
WARNING:
Hazard exposure
Failure to follow these instructions could result in serious injury or death.
Verify that no individuals are exposed to any hazard if the output signal switching device (OSSD)
outputs turn on when the emitter and receiver become aligned.
Optically Align the SLS Components
5.8.3
Verify the sensor mounting (see "Mounting the Emitter and Receiver" on page 32 ).
1.
Verify the optimal alignment, adjusting the sensor rotation with the power on.
2.
Verify that the emitter and the receiver are pointed squarely at each other. Use a straight edge (for example, a
level) to determine the direction the sensor is facing. The sensor face must be perpendicular to the optical ax-
is.
Straight Edge
Straight Edge
NOTE: At power-up, all indicators are tested (flash), then the Scan Code is displayed.
a.
Turn on the power to the emitter and the receiver. If Channel #1 beam is not aligned, the Status and Zone 1
indicators are red, and the Diagnostics Display indicates "CH1". Zone indicators 2–8 are off.
b.
If the green Status and amber Reset indicators are on, go to the next step. If not, rotate each sensor (one at a
time) left and right until the green Status indicator is on. (As the sensor rotates out of alignment, the red Status
indicator turns on). As more beams are aligned, the Zone indicators turns from red to green and the number of
blocked beam indicators decreases.
NOTE: If the emitter Test input is open, the 7-segment Display indicates the total number
of beams in the system (minus one) and all Zone indicators are red (except for 10-beam
systems, where the Zone 1 indicator is green).
c.
© Banner Engineering Corp.