Banner EZ-SCREEN SLS, Instruction Manual

Page: 11 / 114

May 22, 2023
EZ-SCREEN SLS Safety Light Curtain Instruction Manual
11
•
•
•
•
•
•
•
•
•
WARNING:
Read this Section Carefully Before Installing the System
Failure to follow these instructions could result in serious injury or death.
If all mounting, installation, interfacing, and checkout procedures are not followed properly,
this
Banner Engineering Corp. device cannot provide the protection for which it was designed.
The user is responsible for ensuring that all local, state, and national laws, rules, codes, or regula-
tions relating to the installation and use of this control system in any particular application are sat-
isfied. Ensure that all legal requirements have been met and that all technical installation and
maintenance instructions contained in this manual are followed.
The user has the sole responsibility to ensure that this Banner Engineering Corp. device is in-
stalled and interfaced to the guarded machine by Qualified Persons, in accordance with this manu-
al and applicable safety regulations. A Qualified person is a person who, by possession of a recog-
nized degree or certificate of professional training, or who, by extensive knowledge, training and
experience, has successfully demonstrated the ability to solve problems relating to the subject
matter and work.
The Banner EZ-SCREEN SLS is intended for point-of-operation machine guarding and other safeguarding applications. It is
the user’s responsibility to verify whether the safeguarding is appropriate for the application and is installed, as instructed by
this manual, by a Qualified Person.
The ability of the EZ-SCREEN SLS to perform its safeguarding function depends upon the appropriateness of the application
and upon its proper mechanical and electrical installation and interfacing to the guarded machine. If all mounting, installation,
interfacing, and checkout procedures are not followed properly, the EZ-SCREEN SLS cannot provide the protection for which
it was designed .
WARNING:
Install System Only on Appropriate Applications
Failure to follow these instructions could result in serious injury or death.
Use Banner's EZ-SCREEN SLS only on machinery that can be stopped immediately after a stop
signal is issued at any point in the machine's stroke or cycle, such as part-revolution clutched ma-
chines. Under no circumstances may the
EZ-SCREEN SLS be used on full-revolution clutched
machinery or in unsuitable applications.
If there is any doubt about whether or not your machinery is compatible with the EZ-SCREEN
SLS , contact Banner Engineering.
EZ-SCREEN: Typical Application
Figure 1.
Appropriate Applications and Limitations
3.4
© Banner Engineering Corp.