Assembly of the top panel is the same as panelift pFT and pFI.
The reinforcing must be fitted after the panel is in the tracks
in a vertical position with the wheels and hangars fitted and
adjusted.
Special care must be taken when fitting the lower reinforcing
as the hook plates must align correctly with the tracklock of the
short top track bracket Figure 2.7.1 and 2.7.3.
Fit the top reinforcing without hook plates over the top hangar
as shown at section H and previously at Figure 2.4.3.
The second lower reinforcing with hook plates is fixed to align
with the top section of the Tracklock. Refer to section b. This
measurement is taken from the bottom of the folded safety
edge note there is a different measurement for FTL (front
torsion large curve) and FTS (front torsion small curve).
NOTE:
Last step - line up reo on top panel with the Tracklock
bracket.
FIGURE 2.7.1
FIGURE 2.7.3
K
K
B
REFER TO NOTE
TOP PANEL
VIEW H:
REO
H
G
SECTION K-K
FIGURE 2.7.2
2.7 ASSEMBLING THE TOP PANEL & FITTING
REINFORCING TO B&D STORM-SHIELD
™
PFI
Lower reinforcing and hook
plates must align correctly
with the tracklock
TOP REO
REO (ON HOOK PLATE)
TOP PANEL HOOK PLATE
1. LOCATE HOOK PLATE TO POSITION
(REFER TO SIDE VIEW INSERT)
2. FASTEN 2 LOCATING SCREWS
3. LINE UP REO EVENTLY ACCROSS PANEL AND
FASTEN ALL 6 TEK SCREWS
4. LINE UP TOP REO AND
FASTEN ALL SCREWS
16
panelift
®
pFT, panelift
®
Icon
™
pFI, b&D Storm-Shield
™
pFI and Insul-Shield
™
Installation Instructions
Revision 9 - March 2016
