VIEW F:
FASTEN SCREWS
IN DIAGONAL
LOCATION
FIGURE 2.5.3
MID-PANEL
1. LINE UP THE FOLD TO
THE 2ND ENDSTILE
2. FASTEN 3
LOCATING SCREWS
3. LINE UP REO EVENLY
ACROSS PANEL AND
FASTEN ALL SCREWS
2.6 ASSEMBLING TOP PANEL PFT, PFI & PFI SEAL
FIGURE 2.6.4
FIGURE 2.6.6
The top panel can be easily identified by always having a centre stile for use
with an opener and no hinge link cut outs in the curved top edge.
Fit the pFI seal to the top of the top panel as shown in Figure 2.6.4 and Figure
2.6.6 or alternatively fit the seal to the lintel. The fixing points should be spaced
at 300-400mm centres.
First insert the wheels into the top hangers as shown in Figure 2.6.1. Then
assemble top hangers to top corners of the panel as shown in Figure 2.6.2 using
the vertical slots only. The additional two fixings will be fitted to the left and right
side after the panel is lowered into the tracks and adjusted to vertical. The top
panel reinforcing should be fitted as high as possible, refer Figure 2.6.5.
Top Hanger
FIGURE 2.6.3
FIGURE 2.6.2
Ensure all tek
screws indicated
are fitted after
adjusting.
FIGURE 2.6.1
INSTALLING
TOP PANEL
FIGURE 2.6.5
2.5 FITTING REINFORCING & END HOOKS TO BOTTOM
& MIDDLE PANEL OF B&D STORM-SHIELD
™
PFI
Reinforcing and hook plates are fitted to the centre of the bottom and middle panels. Take special note of the detail shown and the
position and quantity of the fixings. b&D Storm-Shield
™
pFI reinforcing must be cut 80mm less than the panel width.
FIGURE 2.5.1
NOTCH SHOWS
LOCATION OF HOLES
UNDERNEATH REO
BENT CORNER
ALIGNMENT
MIDDLE PANEL
A
F
BOTTOM PANEL
FIGURE 2.5.2
FIGURE 2.5.4
15
panelift
®
pFT, panelift
®
Icon
™
pFI, b&D Storm-Shield
™
pFI and Insul-Shield
™
Installation Instructions
Revision 9 - March 2016
