1
BMP 01-EL1PP _ 1A- _ _ _ _ -00 -P _ _ /P _ _ -S4/P _ _ -S75
Magnetic Field Positioning System
english
9
.6
16
Ø
2.
4
M12x1
17
.5
2
2
50
M8x1
40
3
BMP 01-…-S4
BMP 01-…-S75
BMP 01-…-cable
Sensing surface
1)
Marking of the measuring range
2)
Not included in scope of delivery
3)
Mounting position
Target2)
1)
3)
3)
LED Button
Groove
Groove
Measuring range
Detection range
Hole spacing
Housing length
1)
Intended use
The BMP Magnetic Field Positioning System, together with
a machine control system (e.g. PLC) and IO-Link, master
forms a position measuring system. It is intended to be
installed into a machine or system and used in the
industrial sector. Flawless function in accordance with the
specifications in the technical data is ensured only when
using original Balluff accessories. Use of any other
components (with the exception of cylinders) will void the
warranty.
Opening the BMP or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation
and
startup
may only be performed by
trained specialists.
The
operator
is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the BMP will not result
in hazards to persons or equipment.
If defects and unresolvable faults occur in the BMP, take it
out of service and secure against unauthorized use.
Downloading further instructions
The calibration procedure is described in the
comprehensive User’s Guide.
A complete user’s guide can be downloaded from the
Internet at
www.balluff.com
or requested via e-mail from
.
Dimensions and function
The BMP is an intelligent magnetic field positioning system.
It is used primarily for the non-contact detection of the
piston stroke of pneumatic cylinders, grippers and slides
with axially magnetized permanent magnets. The BMP
ensures continuous, absolute position measurement at an
application-relevant level of measuring accuracy.
Green
Yellow
Red
LED
Operating state
Color
State
Green on
Power OK
Inverse
flashing
IO-Link communication active
Yellow off
The target is located within the
configured measuring range.
on
The target is located outside of the
configured measuring range.
Flashing
5 Hz
The excess gain of the
measurement is low.
The measured magnetic field
strength of the target is small.
Red
off
No error
Flashing
5 Hz
Analog current output is open
The CE Mark verifies that our products
meet the requirements of the current
EU Directive.
