![background image](http://html.mh-extra.com/html/baldor/id5601-eo/id5601-eo_installation-and-operation-manual_468808013.webp)
13
1.8 GENERAL PERFORMANCE SPECIFICATIONS
Table 1-8 outlines the General Performance Specifications for the
control.
Table 1-8 General Performance Specifications
Parameter
Specification
Factory
Setting
115 Volt AC Line Input Voltage Operating Range (Volts AC)
1
115 (±15%)
−
208/230 Volt AC Line Input Voltage Operating Range
(Volts AC)
1
208 (-15%) /
230 (+15%)
2
−
Maximum Load (% Current Overload for 1 Minute)
150
−
Horsepower Selection (HP) (Jumper J2)
1/8, 1/4, 1/2, 3/4, 1
1
Carrier Frequency (kHz)
16
7.5
Output Frequency Resolution (Bits)
10
−
Minimum Speed Trimpot (MIN) Range
(% Frequency Setting)
0 - 40
0
Maximum Speed Trimpot (MAX) Range
(% Frequency Setting)
70 - 110
100
Acceleration Trimpot (ACCEL) and Deceleration Trimpot
(DECEL) (Seconds)
.3 - 20
1.5
Slip Compensation Trimpot (COMP) Range at Drive Rating
(Volts/Hz)
0 - 3
1.5
Current Limit Torque (CL) Range (% Full Load)
0 - 200
160
Motor Frequency Setting (Hz) (Jumper J5)
50, 60
60
Output Frequency Multiplier (1X, 2X) Jumper J4)
3
1, 2
1
Minimum Operating Frequency at Motor (Hz)
0.3
-
Speed Range (Ratio)
60:1
−
Speed Regulation (30:1 Speed Range, 0 - Full Load)
(% Base Speed)
4
2.5
−
Overload Protector Trip Time for Stalled Motor (Seconds)
6
-
Undervoltage/Overvoltage Trip Points for 115 Volt AC Line
Input (±5%) (Volts AC)
1
76 / 141
-
Undervoltage/Overvoltage Trip Points for 208/230 Volt AC
Line Input (±5%) (Volts AC)
1
151 / 282
−
Run/Fault Relay Output Contact Rating
(Amps at 30 Volts DC, 125 Volts AC, 230 Volts AC)
1, 0.5, 0.25
−
Operating Temperature Range (°C / °F)
0 - 40 /
32 - 104
−
Notes:
1. Do not operate the drive outside the specified AC line input voltage operating range.
2. The drive is factory set for 208/230 Volt AC line input (Jumper J1 not installed). For 115
Volt AC line input, install Jumper J1 (supplied). See Figure 2-3.
3. Allows the motor to operate up to two times the rated RPM. Constant motor horsepower
will result when operating the drive in the “2X” mode above the motor rated frequency.
4. Dependant on motor performance.
Summary of Contents for ID5601-EO
Page 18: ...18 Figure 2 3 Drive Layout ...