57
Setting the Guide Holders and Bracket
(continued)
Use the two 5/16” nuts on the back of the aluminum block to make the up/down and
side-to-side adjustments. This will ensure the bullets wearable surface is equal between
the bullet holders.
A tilting adjustment is done with the 1/4” bolts on the side “L” shaped brackets. This can
help to get proper wear to the bullets on the front and back.
Adjusting the tilt for the moveable guide is done in the same manner, but the 5/16” bolt
will not have to be loosened to make the adjustment, but the 5/8” bolt will.
Loosen the jam nuts, then use the 1/4” bolts on top of the tilt bracket to adjust the guides
so that they are vertically centered to the blade.
After proper tilting is accomplished, retighten the 1/4” jamb nuts and the 5/8” bolt.
You are now ready to set the bullet guides to the blade (see
Page 54
and
Page 55
for
detailed instruction).
Figure 60
Loosen the 5/16” nuts to make
the up/down adjustments
Loosen the 5/16” nuts to make
the side-to-side adjustments
Adjust tilt with 1/4” bolts
Loosen 5/8” bolt to adjust tilt
Adjust tilt with 1/4” bolts
Loosen 5/8” bolt to adjust tilt
Adjust tilt with 1/4” bolts
Loosen the 5/16” nuts to make
the up/down adjustments
Loosen the 5/16” nuts to make
the side-to-side adjustments
